Replacing the main electrical power fuse, Regulating the mobility of the point of use arm, Recycling the reject water from the a-10 toc – Yamato Scientific WR600S AutoPure User Manual
Page 27: System is not operated for a long time
Replacing the main electrical power fuse
1. Put the system into STANDBY mode by pressing OPERATE / STANDBY for 2 seconds.
2. Turn off the power switch (figure 1, G ) by putting it into the ‘0’ position..
3. Unplug the electrical power cord from the wall and from the system.
4. Remove the fuse holder (figure 1,J ).
5. Remove the blown fuse and replace it with the spare fuse.
Note: Replace the spare fuse in the event that it may need to be replaced later.
6. Replace the fuse holder and plug the power cord back in to the system and to the wall.
Regulating the mobility of the point of use arm
The point of use arm can be adjusted in 2 locations. This adjustment is done by tightening the arm screw(s) with the 6 sided key
(figure 2, K)
Do not overtighten the arm screws. This may block water flow through the arm.
Recycling the reject water from the A-10 TOC
The reject water from the use of the A-10 can be recycled to a feed reservoir. Contact Yamato Technical Service for more details.
System is not operated for a long time
Keep the Autopure WR600 in PRE OPERATE mode when water is not needed. In this mode, the Autopure WR600 will operate
through various cycles to keep the water quality optimum.
If the Autopure WR600 is to shut down for a long time, contact YamatoTechnical Service for
further information.