Yamato Scientific WR600S AutoPure - Manual (Page 13)

Use of the Keypad
The keypad allows the user to activate the different operating modes or to review information about system performance.
KEYPAD ACTION DISPLAY
STANDBY and PRE-OPERATE
Press the OPERATE / STANDBY keypad button for at
least 2 seconds to switch between these two operating
modes.
STANDBY
PRE-OPERATE
MEASURE
In PRODUCT or PRE-OPERATE mode,
Press MEASURE to display temperature
and last TOC value.
CLEANING
The CLEANING function is described in the MAINTENANCE chapter. This is for
cleaning and sanitising the ultrafiltration module.
MENU FUNCTION
Changing the COUNTER time
In PRE-OPERATE mode only,
press MENU for at least 2 seconds.
↓
Select or change the COUNTER time by pressing the
arrow keys. or
↓
Press OPERATE / STANDBY for at least 2 seconds to
accept the COUNTER time.
Note: Moving the point of use trigger forward will initiate the COUNTER and start to
dispense water. The system will dispense water from the point of use gun for the
amount of time that the COUNTER is set to. When the dispensing time is finished
(COUNT = 0), the system will automatically go to STANDBY mode. Move the Trigger
back to the vertical position to go to PRE OPERATE mode.
S T A N D B Y
OPERATE/STANDBY MEASURE CLEANING MENU
P R E - O P E R A T E
T O C
T E M P : 2 2 . 6 ° C
T O C : 3 p p b
OPERATE/STANDBY MEASURE CLEANING MENU
OPERATE/STANDBY MEASURE CLEANING MENU
P R O D . T I M E S E T U P
C O U N T E R : 0 m n
P R O D . T I ME S E T U P
C O U N T E R : 1 3 m n
OPERATE/STANDBY MEASURE CLEANING MENU
P R E O P E R A T E
OPERATE/STANDBY MEASURE CLEANING MENU
OPERATE/STANDBY MEASURE CLEANING MENU