Yamato Scientific HF200 Heating Block - Manual (Page 19)

15
2. How to operate the unit
Auto-start operation
For the auto-start operation
This mode is selected when the operation is to be started automatically in several hours later as
shown below. Since the operation does not stop automatically, it is necessary to stop it manually.
t
Timer start Operation start (auto)
Controller start (manual)
SV：Temperature set value t：Time
1.Turn ON the POWER switch to start power supply.
Z Measured Temp. POWER Fixed Temp.
Set Temp.
Auto Stop
Auto Start
Heater
Alarm
OFF
START
STOP
TIMER
SUB MENU 4sec.
℃
The initial screen is shown for four seconds.
Measured Temp.
Fixed Temp.
Set Temp.
Auto Stop
Auto Start
Heater
Alarm
START
STOP
TIMER
SUB MENU 4sec.
℃
The temperature setting screen appears after the initial
screen has been shown for four seconds.
Indicates the current bath temperature.
Indicates the current set temperature.
SV
Timer set
▼