Yamato Scientific HF200 Heating Block - Manual (Page 15)

11
2. How to operate the unit
Auto-stop operation
For the auto-stop operation
In this mode, the operation stops automatically according to the setting of the timer.
t
Timer operation start (auto)
Operation stop (auto)
SV：Temperature set value t：Time
Quick auto-stop function is to set auto-stop in the course of fixed-value operation. This
section describes the method of operation, in which the auto-stop timer is set at the initial set
time point.
1.Turn ON the POWER switch to start power supply.
Z Measured Temp. POWER Fixed Temp.
Set Temp.
Auto Stop
Auto Start
Heater
Alarm
OFF
START
STOP
TIMER
SUB MENU 4sec.
℃
The initial screen is shown for four seconds.
Measured Temp.
Fixed Temp.
Set Temp.
Auto Stop
Auto Start
Heater
Alarm
START
STOP
TIMER
SUB MENU 4sec.
℃
The temperature setting screen appears after the initial
screen has been shown for four seconds.
Indicates the current bath temperature.
Indicates the current set temperature.
Timer start
▼
SV
Timer set
▼