Yamato Scientific HF200 Heating Block - Manual (Page 17)

13
2. How to operate the unit
Auto-stop operation
5. Start the auto-stop operation.
Measured Temp.
Fixed Temp.
Set Temp.
Auto Stop
Auto Start
Heater
Alarm
START
STOP
TIMER
SUB MENU 4sec.
℃
Keep pressing the START/STOP key.
Auto-stop operation begins.
The timer starts counting when the set temperature is
reached.
・Starting counting of the timer in the auto-stop operation mode
When the set temperature is lower than the bath temperature in the auto-stop
operation mode, the timer does not start counting till the bath temperature reaches
the set temperature.
・The set temperature and the time of timer can be changed even during operation.
Change the set temperature directly with ▼ and ▲ keys. The display changes from
the remaining time to the temperature setting screen, enabling temperature change.
The screen changes automatically to the remaining time display. There is not need
to press the START/STOP key after change.
To change the time of timer, press lightly the TIMER key. The set time display
flashes. Change the time to the desired time with ▼ and ▲ keys. The screen
changes automatically to the remaining time display. There is not need to press the
START/STOP key after change.
6. Time-up
Measured Temp.
Fixed Temp.
Set Temp.
Auto Stop
Auto Start
Heater
Alarm
START
STOP
TIMER
SUB MENU 4sec.
℃
At the set time, the remaining time display changes to
the flashing display of End . This means the
end of the auto-stop operation.
Changes over to End .