Yamato Scientific HF200 Heating Block - Manual (Page 11)

7
2. How to operate the unit
Fixed-value operation（continuous operation）mode
3. Start operation.
Measured Temp.
Fixed Temp.
Set Temp.
Auto Stop
Auto Start
Heater
Alarm
START
STOP
TIMER
SUB MENU 4sec.
℃
Keep pressing the START/STOP key.
Fixed Temp. and Heater lamps go ON and the operation
begins.
When the bath temperature reaches the set
temperature, the Heater lamp flashes. Now the bath
temperature is under control.
With Fixed and Heater lamps ON, the bath temperature
begins rising and the operation begins.
4. Stop operation.
Measured Temp.
Fixed Temp.
Set Temp.
Auto Stop
Auto Start
Heater
Alarm
START
STOP
TIMER
SUB MENU 4sec.
℃
Keep pressing the START/STOP key.
Fixed Temp. and Heater lamps go OFF and the
operation stops.
Fixed and Heater lamps go OFF and the operation
stops.
The temperature can be set over a range from 0.0℃ to 200.0℃.
Note however that the operating temperature range is from the room temperature + 5.0℃
up to 200.0℃.
Displays of the
operation panel
used for fixed-value
operation
POWER switch
▼ and ▲ keys
Measured Temp. screen
Set Temp. screen
Fixed Temp. lamp
Heater lamp
START/STOP key
：
：
：
：
：
：
：
With this switch ON, the power is supplied to
the system. With the switch OFF, power
supply is turned OFF. This switch is a
circuit breaker.
Key to change the set temperature.
Shows the current bath temperature.
Shows the set temperature.
Indicates that the fixed-value operation state
is under way.
ON with the heater energized and flashing
for the controlled state
Operation start/stop key. Keep pressing for a
certain period.