Yamato Scientific BB600 Low Constant Temperature Water Bath - Manual (Page 40)

37
Operation Method
RS485 Communication Function
Other Parameters
Name Identifier Command Setting Value
Key lock LOC R/W
00000：Key lock released
00001：Key lock
Operation
start/stop
RUN R/W
00000：Stop (*3)
00001：Start
Operation type
selection
RST R/W 00000：Fixed temperature operation selected (*3)
Remaining hour
monitor
_TI R
00000：Time-up (*1)
00001～09950：0 hours and a minute to 999 hours and 50
minutes
Output monitor OM1 R
00000：First digit = Heater output
Second digit = Refrigerator output
Third digit = Main output
Fourth digit = Time-up or alarm output
Fifth digit = Overheat prevention output
※ Output state: 0 = Output OFF, 1 = Output ON
Error monitor 1 ER1 R
00000：First digit = Memory error
Second digit = Sensor error
Third digit = AT error
Fourth digit = Heater wire disconnection error
Fifth digit = SSR short error
※ Error state: 0 = No error exists., 1 = An error exists.
Error monitor 2 ER2 R
00000：First digit = Boil-dry error
Second digit = Overheating prevention 1 error
Third digit = Overheating prevention 2 error
Fourth digit
= Internal communication/Temperature input circuit
error
Fifth digit = Unused
*Error state: 0 = No error exists., 1 = An error exists.
Measured
temperature
monitor
PV1 R
(Example)
00100
= 100 °C (when the temperature sensor is a thermocouple
input)
01000
= 100.0 °C (when the temperature sensor is a platinum input)
HHHHH
= Measured temperature over-scale (input common)
LLLLL
= Measured temperature under-scale (input common)
*The measured temperature resolution of the platinum input is
ten times that of the thermocouple input.