Stainless Works Chevy Trailblazer SS 2006-09 Exhausts - Manual (Page 5)

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
SINGLE CATBACK TO FACTORY CONNECTION POINT INSTALLATION
1. Install leadpipe with flange to factory connection point using supplied 3/8”
hardware.
2. Install muffler with (1) 3.5” Accuseal clamp.
3. Install tailpipe using (1) 3.5” Accuseal clamp and hangers.
4. Install tip using 3.5” Accuseal hanger clamp.
FOR ALL SYSTEM INSTALLATIONS
1. Make sure that everything lines up and tighten, starting at the front of the vehicle
and moving toward the rear.
2. Lower Vehicle.
3. Reconnect Battery.
4. Be sure to have adequate clearance around all wires, hoses and lines. If anything
is in contact with the exhaust system, it will melt. Make sure to have at least
½” of clearance and wrap any suspect areas with DEI thermal barrier wrap.
5. After double checking for clearance and making sure all lines, wires and hoses are
secured, drive the car for 10-20 miles and re-check all clamps and clearances.