Stainless Works Chevy Trailblazer SS 2006-09 Exhausts - Manual (Page 4)

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
TRUE DUAL EXHAUST WITH HEADERS INSTALLATION
1. Install X-Pipe into lead pipes and into rubber hanger on the vehicle using (2) 2.5”
Accuseal clamps.
2. Install mufflers using (2) Accuseal clamps on the front of the mufflers and the
dual hanger clamps (saddle clamps with welded hanger) on outlet end of mufflers
and leave loose.
3. Install tailpipes over axle into ends of mufflers using above saddle clamps with
hanger.
4. Install second part of tailpipes and tips in vehicle using (2) 2.5” Accuseal clamps
for tailpipes and hangers welded to (2) 2.5” Accuseal clamps for tips. (True Dual
Standard Outlets). For Center Outlet installation use folded hanger in picture
above with blue grommets and two saddle clamps on rear tails.
DUAL EXHAUST TO FACTORY CONNECTION POINT INSTALLATION
1. Install Y-Pipe with flange to factory connection point using supplied 3/8”
hardware.
2. Install two straight muffler inlet pipes (15” long) along with (2) 2.5” Accuseal
clamps. A special hanger with two saddle clamps will also be used to provide
additional support for these straight pipes and the front of the exhaust system.
This can be installed now or at the end of the installation after everything is in
place.
3. Install mufflers using (2) 2.5” Accuseal clamps on the front of the mufflers and
the dual hanger clamps (2.5” Saddle clamps with welded hanger) on outlet end of
mufflers and leave loose.
4. Install tailpipes over axle into ends of mufflers using above saddle clamps with
hanger.
5. Install second part to tailpipes with tips and hangers using (2) 2.5” Accuseal
clamps.
6. Install second part of tailpipes and tips in vehicle using (2) 2.5” Accuseal clamps
for tailpipes and hangers welded to (2) 2.5” Accuseal clamps for tips. (True Dual
Standard Outlets). For Center Outlet installation use folded hanger in picture
above with blue grommets and two saddle clamps on rear tails.