Skyjacker SKTOY30 User Manual
Skyjacker For the car
IMPORTANT NOTES
-Skyjacker strongly advises taking extreme caution when working with loaded coil springs to
prevent accident or harm.
-On trucks without manual locking hubs, ride height must not be adjusted over 2" above fac-
tory ride height.
-Both coil over assemblies should be adjusted to the same length after installation. It is VERY
IMPORTANT that after installation the coil does not have any slack between the mounting
cups. At no time during axle travel should the coil lose contact with the mounting points.
-When final adjustments are made the upper spanner must be tightened. At no time should
the coil over assembly be ran without the spanner being tight.
Part #
Description
Qty
TOY20153-S
TOYOTA 3” COIL
2
SKY202-S
2”COIL OVER SHOCK
2
SKSPC-TOYLWLG
SHOCK SPACERS-LONG LOWER 2
SKSPC-TOYLWSH
SHOCK SPACERS-SHORT LOWER 2
SPC-50X375
SPACER,1/2”ID X .375 LONG
4
SKY-SEAT20
SPRING SEAT:FOR SKY202-S 2
TTCSKUP-RING
TOYOTA COIL OVER UPPER RING 2
12X4SHB
1/2 X 4 SOCKET HEAD BOLT 2
38X1FTB
3/8 X 1 FINE THREAD BOLT
6
12CTN
1/2-13 COARSE N/I LOCK NUT 2
38FTN
3/8-24 FINE N/I LOCK NUT
6
SW201
SPANNER WRENCH
1
Instructions:
* PreAssemble Coil Overs per instructions on page #4.
Front:
1. With vehicle on flat level ground, measure from center of
front spindle to the top of fender opening. Record this
measurement for later use.
2. Raise the front of vehicle in the center of the front cross
member using floor jack.
3. Support the vehicle on the frame cross member so that the
front tire/wheels are off the ground.
4. Using 19mm wrench remove bottom bolt from bottom of
factory shock. Bolt will be reused to install new Platinum
Series assembly.
5. Using 14mm wrench remove top three retaining nuts from
top of factory coil over assembly. Remove factory coil over
assembly. ( See Photo #1).
6. Attach upper bracket to the top of the new shock using ½"
Allen head bolt and self-locking nut as shown in Photo #2.
Be sure to use the 1/2" x .375" long spacer on each side
of the shock eye.
Photo #1
Pg 1
96-04 Toyota Tacoma
99-04 Toyota Tundra
2-2.5" Platinum Series Coil Over
Installation Guide
Part# SKTOY30
I-SKTOY30 3-06
Photo #2