Quadrox WebCCTV Installation Manual - Manual (Page 8)

WebCCTV Installation Manual 8
Version 4.4 Series
2.2.1.2 Turning power off or restarting
Before shutting down or restarting a WebCCTV, there are some important precautions to make
note of. Because a WebCCTV is constantly recording (24h) activity video on the disk, the hard
disk is used very frequently. If a user shuts down the WebCCTV while it is writing to the hard
disk, there is always a danger of damaging the hard disk. This may result in having an
unbootable WebCCTV afterwards. There are two options:
Restart or shutdown WebCCTV through the normal Windows interface:
1. On the taskbar at the bottom of your screen, click the Start button in the lower left
corner.
2. On the start menu, in the lower right corner, click Shut Down.
3. On the Shut Down Windows dialog box, select the Restart or Shut Down tab.
4. Click OK to shutdown or restart.
5. Wait until the WebCCTV completely has shut down before unplugging the power
cord.
Restart or shutdown WebCCTV by using the shutdown button on the unit itself:
1. On the front of the unit there is a button to shut down the WebCCTV.
2. Because our WebCCTV is ACPI enabled, clicking this button once for a brief
moment will initiate a graceful shutdown. This is handled by the MS Windows XP
embedded Operating System, because it detects the click on the shutdown button
and will shutdown automatically.
3. Please be patient because it can take nearly a minute before the WebCCTV actually
shuts down completely. The WebCCTV has stopped when the green power
indicator has gone out.
4. Wait until the WebCCTV completely has shut down before unplugging the power
cord.
2.2.2 Logging on to the XPe system
For access to the WebCCTV’s operating system, you have to specify a Username and
Password.
The first time you turn on the power of a WebCCTV, after its boot sequence (see above) has
completed, its initial screen will be the Windows XPe logon prompt:
The default Administrative username is: Administrator
The default Administrative password is: webcctvnvr
It is highly recommended to change the Administrative password as soon as possible.
If you use an ‘AZERTY’ keyboard, this becomes zebcctvnvr. See Chapter 2.3.6 how
to change this to Azerty settings.