Quadrox WebCCTV Installation Manual - Manual (Page 33)

WebCCTV Installation Manual 33
Version 4.4 Series
2.5.3 Automatic logon as Operator
In an installation where you are going to leave the configured WebCCTV unit in Operator
mode, make sure that after restarting the WebCCTV it returns to the Operator mode
automatically.
To do this, follow the steps below:
1. Logon to the Operator mode using Operator Mode icon that resides on the desktop.
2. Once you are in the Operator mode, configure the Local Interface.
3. Don’t logout of the Operator mode. Press the Power button to shutdown the machine
and power it on again.
4. Check that WebCCTV server is restarting in the Operator mode.
To make sure that your WebCCTV server restores to the prior state after a power
failure see 4.4 Power On after power failure chapter.
By default the WebCCTV unit restarts every Monday night at 4:20 AM.