MacDon 3020 Pull-Type Windrower - Manual (Page 57)

46
MAINTENANCE/SERVICE
ELECTRICAL
Use electrical tape and wire clips as required to
prevent wires from dragging or rubbing.
Keep lights clean and replace burnt bulbs and
sealed beams.
To replace amber or red light bulbs:
1. Using a screwdriver, pry plastic lens (B) from
fixture.
2. Replace bulb and plastic lens.
NOTE: Bulb trade #1156.
To replace field lamp sealed beam:
1. Use a screwdriver to pry sealed beam from
rubber bezel (C). Work your way around
circumference, taking care not to break sealed
beam.
2. Disconnect wire (D) and connect new sealed
beam.
NOTE: Sealed beam trade #4411
3. Carefully push new sealed beam into rubber
bezel. Make sure it is properly positioned.
REPLACING AMBER OR RED LIGHT BULBS
B
REPLACING SEALED BEAMS
C
D