MacDon 3020 Pull-Type Windrower - Manual (Page 46)

35
OPERATION
STORAGE PROCEDURE
Do the following at the end of each operating
season:
CAUTION:
1. Clean the windrower thoroughly. Never use
gasoline, naphtha or any volatile material
for cleaning purposes. These materials may
be toxic and/or flammable.
2. Cover cutterbar and sickle guards to
prevent injury from accidental contact.
Also:
3. Store in a dry, protected place if possible. If
stored outside, always cover windrower with a
waterproof canvas or other protective material.
4. If machine is stored outside, remove drapers
and store in a dark, dry place.
NOTE: If drapers are not removed, release
tension and angle header so water/snow will
not accumulate on drapers. This accumulation
of weight puts excessive stress on drapers and
header.
5. Lower header onto blocks to keep cutterbar off
the ground.
6. Lower reel completely. If stored outside, tie reel
to frame to prevent rotation caused by wind.
7. Repaint all worn or chipped painted surfaces to
prevent rust.
8. Loosen all drive belts.
9. Lubricate the windrower thoroughly, leaving
excess grease on fittings to keep moisture out
of bearings. Apply grease to exposed threads,
cylinder rods and sliding surfaces of
components. Oil sickle components to prevent
rust.
10. Check for worn or broken components and
repair or order replacements from your dealer.
Attention to these items right away will save
time and effort at beginning of next season.
11. Replace or tighten any missing or loose
hardware. See Specifications section for torque
charts.