MacDon 3020 Pull-Type Windrower - Manual (Page 22)

11
OPERATION
DETACHING WINDROWER FROM TRACTOR
CAUTION: To prevent accidental
movement of tractor, shut off engine,
engage parking brake, and remove
key.
To maintain stability, always lower the reel and
cutterbar completely. Block windrower wheels
before detaching from tractor.
Park machine on flat level surface.
Move remote cylinder control valve lever back
and forth to relieve stored hydraulic pressure.
CAUTION: For 36 ft. units, windrower
must be in transport position; or, if in
field position, tractor must be
situated as in a right turn to relax
stabilizer spring and slacken chain.
1. Remove pin (A) and rotate jack to upright
position. Replace pin, allowing jack handle to
swing freely.
2. Lower jack to take weight off tractor drawbar.
3. Pull back spring loaded collar (G) on
telescoping driveline yoke and remove yoke
from tractor PTO shaft.
4. Disconnect hydraulic hoses and electrical
harness. Store in holes provided in drive frame.
DETACH DRIVELINE
G
LOWER JACK
A
STORE HOSES AND WIRING HARNESS