MacDon 3020 Pull-Type Windrower - Manual (Page 48)

37
MAINTENANCE/SERVICE
GREASING THE WINDROWER
Use an SAE Multi-Purpose High Temperature
Grease with Extreme Pressure (EP) Performance
and containing at least 1.5% molybdenum
disulphide.
Also acceptable is an SAE Multi-Purpose Lithium
Base Grease.
The following greasing points are marked on the
machine by decals showing a grease gun (A), and
grease interval (B) in hours of operation. Log your
hours of operation and use the "Maintenance
Checklist" provided to keep a record of scheduled
maintenance.
Procedure:
1. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
2. Inject grease through fitting with grease gun
until grease overflows fitting.
3. Leave excess grease on fitting to keep out dirt.
4. Replace any loose or broken fittings
immediately.
5. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
10 Hours or Daily:
DANGER: Stay clear of driveline until
all movement has stopped.
Entanglement with rotating driveline
will cause serious personal injury or
death. Avoid loose fitting or dangling
clothing.
1. Telescoping Driveline (C) - three fittings
SAMPLE GREASE DECAL
STAY CLEAR OF ROTATING DRIVELINE
TELESCOPING DRIVELINE
C