MacDon R85 Rotary Disc 13 Foot - Manual (Page 63)

OPERATION
169454
61
Revision C
6.14 HEADER LEVELLING
The header support linkages are factory set to
provide the proper level for the header, and
should not normally require adjustment. The
float springs are NOT used to level the header.
If the header is NOT level, check the tire
pressures ensuring they are properly inflated.
Refer to Section 7.9.3 Tire Inflation.
If the header cannot be leveled, damaged
components in the header support system may
be the cause. See your MacDon Dealer.
6.15 UNPLUGGING THE HEADER
DANGER
Stop tractor engine, and remove key before
removing
plugged material from header. A
child or even a pet could engage the drive.
a. Stop forward movement of the tractor, and stop
the PTO.
b. Raise the header fully, shut down the tractor
engine, and remove the key.
c. Engage lift cylinder lock-out valves.
WARNING
Wear heavy gloves when working around
cutterbar.
d. Open cutterbar doors, and clean off cutterbar or
rolls by hand.