MacDon R85 Rotary Disc 13 Foot - Manual (Page 110)

MAINTENANCE AND SERVICING
169454
108
Revision C
7.8.2 Red Tail/Brake Lights
7.8.2.1 Light Bulb Replacement
a. Using a Phillips screwdriver, remove screws from
fixture, and remove plastic lens.
b. Replace bulb, and re-install plastic lens and
screws. Bulb - Trade #1157.
7.8.2.2 Fixture Replacement
a. Cut plastic cable tie (A) securing harness covering
to light (B).
b. Retrieve connections (C) from inside harness
covering approximately 6 inches (150 mm) from
light, and disconnect wires. If necessary, remove
tape.
c. Remove nut (D) securing light to frame, and
remove light. Pull wires through hole in frame.
d. Feed connectors of new light (B) through hole in
bracket, and position light onto frame.
e. Install nut (D), and tighten.
f. Connect wires to connectors (C) in harness, and
re-secure harness covering with tape and plastic
tie (A) as required.
D
A
C
B