MacDon R85 Rotary Disc 13 Foot - Manual (Page 109)

MAINTENANCE AND SERVICING
169454
107
Revision C
7.8 ELECTRICAL
a. Use electrical tape and wire clips as required to
prevent wires from dragging or rubbing.
b. Keep lights clean, and replace defective bulbs.
DANGER
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
7.8.1 Amber Hazard/Signal Lights
7.8.1.1 Light Bulb Replacement
a. Using a Phillips screwdriver, remove screws from
fixture, and remove plastic lens.
b. Replace bulb, and re-install plastic lens and
screws. Bulb - Trade #1157.
7.8.1.2 Fixture Replacement
a. Cut plastic cable ties (A) securing harness
covering to light (B).
b. Retrieve connections (C) from inside harness
covering (approximately 6 inches (150 mm) from
light), and disconnect wires. If necessary, remove
tape.
c. Remove the two nuts (D) securing light to bracket,
and remove light. Pull wires through hole in
bracket.
d. Feed connectors of new light (B) through hole in
bracket, and position light onto bracket.
e. Install nuts (D), and tighten.
f. Connect wires to connectors (C) in harness, and
re-secure harness covering with tape and plastic
tie (A) as required.
A
D
B
C