Configuration, Hardware_configuration, Hardware configuration – Precision Turbo and Engine BigStuff3 GEN3 PRO SEFI (LS1) System Hardware & BigComm Software User Manual
Page 31
BigStuff3 Pro SEFI System (LS1)
Version 1.0
30
16. Configuration
The BigStuff3 ECU needs to be configured to the engine it will control. For example, the ECU
needs to know if it is operating a 4, 6 or 8 cylinder engine along with other important engine
parameters and variables. The initial configuration steps can be accomplished with the vehicle
ignition key in “run” position and the engine off. The ECU must be supplied with 8V – 14V for
the ECU to be “live”.
From the tool bar on Main Menu screen, left click on the “Configuration” and the drop down
screen below will open.
17. Hardware Configuration
Keep the left mouse button depressed and slide the mouse pointer down until “Hardware
Configuration” is highlighted. Release the left mouse button. The screen below will open.
“Hardware Configuration” drop-
down.
Main tool bar
To set up, go to