Pololu Orangutan SVP - Manual (Page 23)

16. Servo power selection
To use your servo ports, you will need to connect a power source (no power source is connected by default). You
can install two 1×3 male headers at this location and use two shorting blocks to select either VCC or VADJ for
servo power.
17. LCD backlight connection and structural support
If you choose to mount a 16×2 LCD on the Orangutan SVP as is done in the assembled version, you will want to
solder in the two single-pin female headers at this location. This prevents the LCD from tipping down on to the
board and also powers the backlight (if your LCD has one).
Pololu Orangutan SVP User's Guide © 2001–2012 Pololu Corporation
5. Getting Started Page 23 of 37