Omnitron Systems Technology iConverter 1 Module Redundant Power Chassis - Manual (Page 22)

The four sensors are compatible with APC PowerShield product. The table
below defines the pinouts for both units.
C P A
# n i P
r e t r e v n o C i
s i s s a h C
# n i P
n o i t p i r c s e D t i u c r i C d e s o l C t i u c r i C n e p O
3 2 n r u t e R l a n g i S A / N A / N
4 1 e c r u o S r e w o P r e w o P y t il i t U r e w o P y r e t t a B
5 3 e v r e s e R y r e t t a B d e g r a h C - ll u F y r e t t a B t s e T - f l e S s l i a F y r e t t a B
6 5 n o i t i d n o C y r e t t a B t n e s e r P y r e t t a B g n i s s i M y r e t t a B
7 7 y r e t t a B w o L y t i c a p a C r a e N y r e t t a B y t i c a p a C % 0 2 < y r e t t a B
Table 6: APC PowerShield Alarm Contact Configuration
5.2 Contact Closure Sensor Configuration
The contact closures can be used to alert the network management system of
problems associated with the remote location. The contact closure sensor can
also detect the opening and closing of a switch, such as a equipment door
being opened or closed. The figure below illustrates this application.
Open Door Alarm Condition
Figure 14: Chassis Configured for Open Door Alarm
Page 22