MTS SWIFT 10 ATV Sensor - Manual (Page 69)

Road and Track Vehicles
SWIFT 10 ATV Sensors Installing the Transducer 69
Note If the jack screws used to remove the slip ring bracket are still in the slip
ring bracket, remove them before continuing.
Use the eight M8 fasteners provided to attach the slip ring bracket to the
transducer and inner hub adapter. Hand tighten the bolts.
Lubricate the threads and under the head of each fastener with Molykote g-n
paste.
Bolt Torque Sequence
9. Tighten the eight M8 mounting bolts securing the transducer and modified
rim assembly to the inner hub adapter.
A. Following the inner bolt pattern sequence shown in the previous figure,
torque the eight M8 bolts (A through H) to the value for the first
increment shown in the following table.
B. Repeat Step 9A for the second increment.
Note To minimize negative clamping effects, you must torque the bolts in the
sequence shown.
1 6
9
20
15
3
7
11
18
14
5 2
10
19
16
4
8
12
17
13
Inner Bolt
Pattern
Outer Bolt
Pattern
S10-12
E
H
D B
F
G
A C
Jack Screw
Holes
T ORQUE I NCREMENT M8 B OLT S IZE
1st Increment 19 N•m (14 lbf• ft)
Final Increment 38 N•m (28 lbf• ft)