MK Diamond MK-101Pro24 JCS - Manual (Page 20)

20
MK-101 Pro24 JCS ASSEMBLY
Shaft Lock
Pushbutton
(A)
Position Movable Cutting Table
to the front of the saw and
raise the Blade Guard by
loosening the wingnut.
(B)
Locate the Shaft Lock push
button on the underside
of the Cutting Head.
(C)
Depress and hold the Shaft
Lock pushbutton and remove
Retaining nut and Outer Flange
using the Blade Wrench.
(D)
Install Diamond Blade
onto Blade Shaft.
(E)
Verify the Blade is seated on
the Blade Shaft and direction
of rotation is correct.
(F)
Install Retaining Nut and Outer
Flange, depress and hold the
Shaft Lock push button
and tighten.
DIAMOND BLADE INSTALLATION
When installing the Retaining Screw, do not “cross-thread” and DO NOT over
tighten the screw.
NOTE: