Lenze Loader L-force Loader - Manual (Page 7)

L
DMS 4.0 EN - 07/2007 7
L-force Loader
System requirements
Supported target systems
2 System requirements
The following minimum requirements on hardware and software must be met in order to
use the »L-force Loader«:
r Microsoft® Windows® 2000 (as of Service Pack 2) or Windows® XP
r Microsoft® Internet Explorer as of version 5.0
r IBM® compatible PC with Intel® Pentium® processor with at least 600 MHz
r 256 MB RAM
r 120 MB free hard disk capacity
r Pointer device (mouse, track ball, etc.)
r Free slots/interfaces according to the requirements of the fieldbus interface module
used.
2.1 Supported target systems
The »L-force Loader« supports the following target systems:
Target system as of version
8200 motec/vector 1.4
9300 hoist 0.4
9300 Servo PLC 0.2
9300 servo cam profiler 1.0
9300 servo position controller 1.0
9300 servo register controller 1.0
9300 servo inverter 1.0
9300 vector 1.0
9374 terminal extension 1.0
9400 StateLine / HighLine 1.0
Drive PLC 0.4
ECS axis controller 1.3
ECS power supply module 1.2
EthernetCAN 2180 1.0
I/O system 1.0
ModemCAN 2181 1.0
starttec 1.0