Lenze Loader L-force Loader - Manual (Page 36)

L-force Loader
Appendix
Error numbers, causes & remedies
36 DMS 4.0 EN - 07/2007
L
7 Appendix
7.1 Error numbers, causes & remedies
Error number Cause Remedy
0001h ...
BFFFh
The Online Help for the system bus configurator provides information about these error
numbers.
C000h Error while opening/closing a file. Close the program and restart it. If the
problem still occurs, check the path and the
file name of the file causing the error.
C001h Internal program error (invalid handling). Restart the program. If the problem still
occurs, contact the Lenze Hotline.
C100h Error while reading the GDC parameter set
file.
Try to reload the file. If the problem still
occurs, the GDC parameter set file is not
valid. Create a new file with GDC.
Faulty GDC parameter set file:
C101h
Error in section "ParamSet". Create a new GDC parameter set file with
GDC.
C102h Section "ParamSet" is missing.
C103h UserInfo cannot be read.
C104h PDB-ID cannot be read.
C105h Target system name cannot be read.
C106h Variable version cannot be read.
C200h A code specified in the parameter set file
cannot be found in the device description.
If the device description has been assigned
manually, ensure that the device description
corresponds to the parameter set file.
Faulty GDC device description:
C201h
Error in section "DefaultParamTypes". If the device description has been created
with DDS, create a new file. If the problem
still occurs, contact the Lenze Hotline.
C202h Section "ParamSet" is missing.
C203h PDB cannot be read.
C204h PDB-ID cannot be read.
C205h Name of ParamSet cannot be read.
C206h SWID_B cannot be read.
C207h Name of ParamSet is unknown.