Lenze I/O system 1000 - Manual (Page 37)

Lenze · I/O system 1000 · commissioning guidelines for the PLC Designer · DMS 1.2 EN · 11/2012 · TD05
37
5 Parameterising I/O modules in the »PLC Designer«
5.3 Parameterising I/O modules on the CANopen bus coupler module
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.3 Parameterising I/O modules on the CANopen bus coupler module
If you double-click the CANopen bus coupler module (EPM-S110) in the Device view of the PLC
Designer, the settings and properties of the bus coupler module are displayed in the Editor view.
• The All parameters tab displays the parameters of the bus coupler module and all attached I/O
compound modules in a hierarchical structure.
• The following example displays the setting parameters of an "EPM-S400":
Optionally, you can display the settings and properties of an individual I/O compound module by
double-clicking the corresponding one in the Device view.
• The Modules tab serves to make the settings desired for the selected I/O compound module (for
this example, an "EPM-S400" has been selected):