Lenze I/O system 1000 - Manual (Page 35)

Lenze · I/O system 1000 · commissioning guidelines for the PLC Designer · DMS 1.2 EN · 11/2012 · TD05
35
5 Parameterising I/O modules in the »PLC Designer«
5.1 Parameterising I/O modules at the backplane bus of the L-force Controller
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5 Parameterising I/O modules in the »PLC Designer«
By means of examples, this chapter describes how to parameterise I/O compound modules in the
»PLC Designer«.
5.1 Parameterising I/O modules at the backplane bus of the L-force Controller
If you double-click an I/O compound module in the Device view of the PLC Designer, the settings and
properties of the I/O compound module are displayed in the Editor view.
• The Parameter tab serves to make the settings desired for the selected I/O compound module
(for this example, an "EPM-S400" has been selected):