Leica Biosystems SP2600 - Manual (Page 39)

39 Leica SP 2600 – Ultramilling attachment
5. Operation
Ending the pre-milling procedure
• Press RUN STOP or RUN ENABLE to stop the sledge (buttons (29), (30) -
Chapter 5.4.10, page 33 - Leica SM2500 manual) - or, when working in
‘PROG’ mode of operation, wait for the programmed number of strokes to
be finished (see chapter 5.4.3, page 26, Leica SM2500 manual).
• If the specimen sledge has not stopped in the front limit position, activate
manual mode of operation MAN (button (5) - chapter 5.4.3, page 26,
Leica SM2500 manual) and move the specimen to the front limit position
(via buttons (58) or (59) - chapter 5.4.14, page 37- SM2500 manual) .
• Stop miller rotation (button (37) - chapter 5.4.11, page 34 - Leica SM2500).
After switching off the milling spindle (button (37) - chapter. 5.4.11,
p. 34 - instruction manual Leica SM2500) the miller continues to
rotate for a little while!
Risk of injury!
• Slide plexiglass protective cover to upper position.
Never touch the milling spindle while it is rotating and/or while
the plexiglass cover is shut, no matter whether the spindle is ro-
tating or not.
• Remove the miller holder containing the pre-miller.
or