Leica Biosystems SP2600 - Manual (Page 15)

15 Leica SP2600 – Ultramilling attachment
4. Installation
4.2 Leica SP2600 standard delivery
Standard delivery includes:
1 Basic instrument Leica SP2600 (Ultramilling
attachment)
1 Calibrating device with dial gauge for miller
adjustment
3 Holders, each with two springs, for pre- and
finishing millers, one holder delivered attached
to the instrument.
1 Carrier for Leica SP2600 Ultramilling device
when not in use
1 Tool set:
1 Allen key, size 2.5, with handle
1 Allen key, size 4.0
1 Allen key, size 4.0 with handle
1 Allen key, size 5.0 with handle
1 Allen key, size, 8.0
1 Power cord – type KN 2/5 7,5 V
1 Box level
1 Plexiglass block, 19 x 33 x 53 mm
1 Balance weight, installed in one of the miller
holders
1 Flat belt
1 Dust cover
1 Supplementary instruction manual for Leica
SP2600, to be used in conjunction with the
Leica SM2500 instruction manual
- German
- English
Millers and specimen holders are not
included in the instrument standard
delivery but have to be ordered sepa-
rately, in accordance with each user’s
specific application(s).
Mounting instructions for all accesso-
ries and/or references to the corre-
sponding chapters of the instruction
manual Leica SM2500 can be found in
chapter 5.6 of this instruction manual.
4.3 Site requirements
For site requirements, please refer to chapter 4.2
of the Leica SM2500 instruction manual.
4.4 Unpacking, transport, installation
Be sure to follow the unpacking in-
structions (attached to the outside of
the instrument shipping crate)!
Never remove or modify any of the
safety devices installed on the instru-
ment and/or accessories!
The Leica SP2600 ultramilling attach-
ment is supplied only in conjunction
with the Leica SM 2500 microtome
(Leica SM2500 microtomes already in-
stalled at a customer’s site must be re-
turned to the manufacturer for upgrad-
ing with a Leica SP2600 ultramilling
attachment).
For instructions on how to install / set up the Lei-
ca SM2500 please refer to chapter 4 of the Leica
SM2500 instruction manual.