Landoll 2410F Weatherproofer I - Manual (Page 52)

3-36 F-735-0114 Edition
ASSEMBLY INSTRUCTIONS
Final Assembly
1. Attach a tractor to the implement and charge the lift
system hydraulics as described in “Hydraulic Lift
System” on page 4-3.
2. Install the 1-1/2 x 16 lockouts on both 3-1/2 x 16
cylinders on the frame.
3. Connect lights to the tractor and verify operation.
4. Check tires for proper inflation.
5. Level the Weatherproofer I from front to rear as
described in “Leveling (Front-to-Rear)” on
page 4-4.
6. Inspect the final implement assembly, and verify that
all bolts have been tightened, cotter pins spread, and
that there are no leaking hydraulic connections.

CAUTION
7. Rotate each disc gang to verify that each gang
rotates freely. Adjust any scrapers that may have
shifted during shipment or assembly.
8. Lubricate the Weatherproofer I at all locations (See
“Lubrication Maintenance” on page 4-10.)
9. Touch up with paint any areas that may have been
scratched during moving, handling, or assembly.
10. Thoroughly read and understand the operating
section before using the Weatherproofer I.
Figure 3-27: 1,200 Foot-Pounds of Torque
Tighten all 1-3/4” nuts to 1,200 foot-pounds of
torque (See Figure 3-27.)
300
POUNDS
PULL
4 FOOT
2 d410 010943