Landoll 2410F Weatherproofer I - Manual (Page 37)

ASSEMBLY INSTRUCTIONS
3-21
Figure 3-14: 7 Pin Connector Detail and Wiring Chart
Light Installation
NOTE
See Figure 3-13 for Light and Bracket Installation.
1. Attach the LH and RH light bar assemblies to the
main frame by locating on the front side of the rear
tower plate just below the main frame. Place the light
bar plate on the front side of the light bar tubes.
Secure the light bar assemblies and the light bar
plate using 1/2-13 x 3-3/4 hex head cap screws and
hex lock nuts (See Figure 3-13.)
2. Attach amber lamps and outer to the LH and RH
light brackets using 1/4-20 X 1-1/4 hex head cap
screws and hex lock nuts.
3. Attach red brake lamps to inner tail light mounting
bracket supports using 1/4-20 x 1-1/4 hex head cap
screws and hex lock nuts.
4. Connect warning light harnesses to lights.
5. Attach SMV emblem on the back side of the rear fold
tower rear plate using 1/4-20 x 1 hex head cap
screws and hex lock nuts.
NOTE: IF REPAIRING OR REPLACING THE 7 PIN
CONNECTOR, MATCH THE LETTERS AT THE
BACK OF THE HARNESS TO THE 7 PIN CONNECTOR
AS SHOWN. THE COLOR OF THE WIRE JACKET
DOES NOT NECESSARILY MATCH THE COLOR
MARKING OF THE 7 PIN CONNECTOR.
4-PIN
CONNECTION
7-PIN
CONNECTION
C
A
B
D
BRN. 6
GRN. 5
YEL. 3
GRND. 1
WIRING CHART
#1 WHITE
#2 BLACK
#3 YELLOW
#6 BROWN
#5 GREEN
#4 RED
#7 BLUE
FACING 7-PIN CONNECTOR
electrical connector op