Disc gang installation - wing frame, Danger – Landoll 2410F Weatherproofer I User Manual
Page 29
ASSEMBLY INSTRUCTIONS
3-13
Figure 3-7: Disc Gang Installation - Wing Frame (2410F-9-24)
Disc Gang Installation - Wing
Frame
DANGER
1.
Assemble the disc gang assemblies to the wing
frames using clamp plates, four bolt plates, 3/4-10 x
2 grade 8 hex head cap screws, 3/4-10 x 2-1/4 grade
8 hex head cap screws, 3/4-10 x 10 grade 5 hex
head cap screws (2410F-7 models), 3/4-10 x 11
grade 5 hex head cap screws (2410F-7 and 2410F-9
models), 3/4 flat washers, and hex lock nuts (See
Figures 3-6 and 3-7)
FRAME ASSEMBLY
RIGHT REAR DISC
GANG ASSEMBLY
RIGHT FRONT DISC
GANG ASSEMBLY
3/4-10 X 2-1/4
HEX HEAD CAP
SCREW GR8
FOUR BOLT
PLATE
3/4-10 X 11 HEX
HEAD CAP
SCREW GR8
3/4-10 X 11 HEX
HEAD CAP
SCREW GR5
3/4 FLAT WASHER
3/4-10 X 2 HEX
HEAD CAP
SCREW GR8
SLOTTED
CLAMP PLATE
3/4-10 HEX
LOCK NUT
LEFT REAR DISC
GANG ASSEMBLY
LEFT FRONT DISC
GANG ASSEMBLY
2410f-9-24 disc gang inst
Disc blades are extremely sharp. Exercise
extreme care when working on or near disc
blades. Do not allow disc to roll over or fall onto
any body part. Do not allow wrenches to slip
when working near disc blades. Never push
wrenches toward disc blades. Do not climb over
machine above disc blades. Failure to stay clear
of disc blade edges can cause serious personal
injury or death.