Landoll 2410F Weatherproofer I - Manual (Page 23)

ASSEMBLY INSTRUCTIONS
3-7
Weatherproofer I Wing and
Extension Installation
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.

WARNING
1. Assemble RH and LH wing weldments to the main
frame assembly using hinge pin, 1-3/4 thrust washer,
1/2 x 2-1/4 grooved alloy pin, and 1-1/4 - 7 hex lock
nut (See Figure 3-3.)
NOTE
Thrust washers are located in between hinge ear plates
of wing.
2. Position the 1-3/4 X 7-3/4 pin into the holes of the
wing frame lock plates. Secure it with (2) 3/8 X 3
spring slotted pins.
3. Connect base end of each 4 x 24 wing fold hydraulic
cylinder to the top of the front and rear tower plate
assembly with ports facing downward using 1 x
7-5/16 pin, 1W” washer, and spring slotted pin.
4. Connect rod end of each 4 x 24 hydraulic cylinder to
wing through holes in the hinge fold plates using 1 x
8-3/4 pin, 1”N flat washer, and 5/16 x 2 spring slotted
pin.
5. On 2410F-9-24 model only, attach extension
weldment to RH and LH wing assemblies using
3/4-10 x 8 hex head cap screws, extension backer
plate, and hex lock nuts.
6. Add shank clamp assemblies to extension
weldments using shank clamp bolt and 1-8 flange
head top lock nut. See Figures 2-1 and 2-2 for
shank placement dimensions.
7. Tighten all hardware to the recommended torques
shown in Table 2-1.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, wheel lift, and pull hitch)
manually. Use a hoist or a forklift to move these
parts into position.