Landoll 7431 VT Plus - Manual (Page 87)

OPERATION AND MAINTENANCE
4-19
7. Check that tires are of proper size, load rating, and
inflated to manufacture specifications before
transporting. Check wheel lug bolts to insure
tightness.
8. Know the transport heights and widths of the unit
before transporting. Attachments such as leveling
harrows can increase the transport dimensions of the
implement. Use caution when transporting near
bridges and power lines.

WARNING
9. Raise the unit to full transport height.
10. Install transport locks on both lift and fold systems.
Do not depend solely on implement hydraulics for
transport. (See Figure 4-20.)

WARNING
11. Transport during daylight hours whenever possible.
Always use flashing warning lights, except where
such use is prohibited by law. Make sure lights,
reflectors and SMV emblem are clearly visible and
operating. Remove any obstructions such as dirt,
mud, stalks or residue that restricts view before
transporting.
12. Be sure to disassemble rear jack assembly and
move into transport position. See Figure 4-21 before
moving machine.
13. To increase stability and reel clearance on center
frame, use hydraulic leveler to roll the unit forward.
Figure 4-20: Installed Transport Locks
Figure 4-21: Rear Jack Transport Position
Electrocution can occur without direct contact.
Failure to use transport lock pins during
transport may result in permanent equipment
damage, serious injury, or death.
1-3/8 x 10 TRANSPORT
LOCKOUT
L PIN
1/8 HAIR PIN
6230translock2
rear jack transport position
REAR JACK
ASSEMBLY
REAR
FRAME