Landoll 7431 VT Plus - Manual (Page 29)

ASSEMBLY INSTRUCTIONS
3-5
Leveler Assembly
1. Install a hardened steel wear bushing in the leveler L
link (See Figure 3-2.)
2. Attach the leveler L link to the front mount of the
center frame with a 1-8 x 4-1/2 hex head cap screw
and hex lock nut.
3. With a 1-8 x 4 hex head cap screw and hex lock nut
attach the leveler ball joint link to the leveler L link.
4. Connect the bottom end of the leveler ball joint link to
the rear mounting holes of the hitch using a 1-8 x
4-1/2 hex head cap screw and hex lock nut.
NOTE
When the hitch is in the upper mounting position, the
leveler ball joint link is mounted in the lower holes. When
the hitch is in the lower position, the link is mounted in the
top mounting holes. See Section 4, “Hitch Adjustment”
for proper adjustment.
5. Slide one end of the 13” link over the leveler screw
assembly. Slide the large end of the 8” link over the
other link and secure with a 1” flat washer and 5/16”
x 2-1/2 spring slotted pin. Repeat this for the other
side of the leveler screw assembly.
6. Attach the bottom end of the 8” leveler links to center
frame mount located in the middle of the frame using
1" x 7-7/8” leveler pin, washers, and 5/16” x 2-1/2”
spring slotted pins.
7. Secure the rear of the 13” leveler links in the third
hole down from the top of the mounting plates
located on the center lift using 1" x 7-7/8” leveler pin,
washers, and 5/16” x 2-1/2” spring slotted pins.