Landoll 7431 VT Plus - Manual (Page 55)

ASSEMBLY INSTRUCTIONS
3-31
Conditioner Reel Installation
1. Assemble 1 x 8 adjustment bolt through adjustment
pin on frame, 1" lock washer, (2) 1-8 hex nuts, and
17" heavy spring assembly.
2. Install 1-1/2” flange bearing into reel arm. Slide in
1-1/2” pivot bushing.
3. Attach reel arm to upper hole on rear center or wing
frame or double mount using 1-8 x 6-1/2 hex head
cap screw and hex lock nut.
4. Assemble 17" heavy spring assembly to reel arm
using 1" pivot pin, and 5/16 x 1-1/2” spring slotted
pins. Set pin centers to 21" dimension as shown in
Figure 3-24.

WARNING
5. Attach reel/gang bar assembly to reel arms using
gang bar mount plate, 3/4-10 x 6 hex head cap
screws and double hex lock nuts. Refer to pages 2-7
thru 2-16 for reel gang bar placement locations.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, lift, pull hitch, or reel/gang bar
assembly manually. Use a hoist or a forklift to
move these parts into position.