Landoll 7431 VT Plus - Manual (Page 70)

4-2 F-561-0113 Edition
OPERATION AND MAINTENANCE
Tractor Preparation
The Landoll 7431 VT Plus is designed to be pulled by
tractor equipped with a double lip or clevis type hitch. If
your tractor is not equipped as such, you need to
purchase the hitch from your local tractor dealer. If your
VT Plus is equipped with the clevis option, this should be
removed. The clevis option is only for transport use.
Before attaching the VT Plus, prepare the tractor as
follows:
1. Inflate the rear tractor tires equally and add ballast
according to the tractor operator’s manual.
2. Lock the tractor drawbar in the center position.
VT Plus Preparation
Figure 4-1: Disc Scraper to Disc Blade
1. Prior to operating the 7431 VT Plus, inspect it
thoroughly for good operating condition.
2. Replace worn or missing parts.
3. When the machine is new, check the bolt tightness
after a few hours of operation. Tighten any loose nuts
or bolts. Check the lift wheel lug bolts daily.
4. Check the lift wheel tire inflation. Inflate all tires
equally to avoid side draft. Follow the tire
manufacturer’s recommended pressures listed on
the sidewall of the tires.
5. Check disc scrapers for proper adjustment to the disc
blade (See Figure 4-1.)
6. Lubricate the machine as shown in “Lubrication
Maintenance” on page 4-21 (See Figure 4-22.)
1/8”
7430 scraper adj