beautypg.com

Figure 3-37: yellow reflector decal placement, Final assembly, Warning – Landoll 7450 VT Plus User Manual

Page 52

background image

3-34

F-607-0114 Edition

ASSEMBLY INSTRUCTIONS

WARNING

14. Attach reel/gang bar assembly to reel arms using

gang bar mount plate, 3/4-10 x 6 hex head cap
screws and double hex lock nuts. Refer to Figures
2-1 t
hru 2-6 for reel gang bar placement locations.

15. Attach yellow reflector decals on outer arms (See

Figure 3-37.) Decals are located in the manual tube.
Reflector decal locations also shown in Figures 2-1
thru 2-6.

Figure 3-37: Yellow Reflector Decal Placement

Final Assembly

1.

Attach a tractor to the implement and charge the lift
system hydraulics as described is “Hydraulic Lift
System” on page 4-3.

2.

Connect the hydraulic hoses on the hydraulic leveler
to the tractor. Fully extend and retract the hydraulic
leveler several times to remove any air.

3.

The fold system must be purged of air and filled with
oil BEFORE attempting to fold the implement. Air in
the system will allow the wings to fall uncontrollably
and may result in implement damage. Follow
instructions for charging the hydraulic fold system as
described in “Hydraulic Fold System” on page 4-5.

4.

Connect lights to the tractor and verify operation.

5.

Check tires for proper inflation

6.

Level the implement from side to side as described in
“Leveling (Side to Side)” on page 4-8.

7.

Inspect the final implement assembly, and verify that
all bolts have been tightened, cotter pins spread, and
that there are no leaking hydraulic connections.

8.

Rotate each disc gang to verify that each gang
rotates freely. Adjust any scrapers that may have
shifted during shipment or assembly.

9.

Lubricate the implement at all locations (See
“Lubrication Maintenance” on page 4-21.)

10. Touch up with paint any areas that may have been

scratched during moving, handling, or assembly.

11. Thoroughly read and understand the operating

section before using the implement.

Do not attempt to lift heavy parts (such as the
frame, disc gangs, lift, pull hitch, or reel/gang bar
assembly manually. Use a hoist or a forklift to
move these parts into position.

REEL ARM STOP
TO INSIDE

NOTE: DO NOT USE
MACHINE BUSHING
HERE

7450 reel arm stop

YELLOW
REFLECTOR
DECAL