Landoll 7450 VT Plus - Manual (Page 23)

ASSEMBLY INSTRUCTIONS
3-5
Figure 3-4: Dual Tire Scraper Installation
Dual Tire Scraper Installation
Refer to Figure 2-7 for dual tire scraper placement.
1. Attach scraper mount to center frame using u-bolts
and 3/4-10 hex lock nuts (See Figure 3-4.)
2. On inner dual tires, attach scraper to scraper mount
in between dual tires using 3/4-10 x 1-3/4 hex head
cap screws and hex lock nuts.
3. On outer dual tires, attach scraper to scraper mount
in between dual tires using scraper plate, 3/4-10 x
2-1/4 hex head cap screws and hex lock nuts.
Inner Wing Frames
1. Place the inner wing frames on top of the wing gang
assemblies and attach using 3/4-10 x 2 and 3/4-10 x
8-1/2 hex head cap screws and hex lock nuts (See
Figure 3-3.)
2. Assemble the tire and wheel assemblies (p/n
156952) to the wing frames. The wings use 12.5L x
15 (GY-FI) load range F tires with 8 bolt wheels and
2-1/4” slip-in spindles. Torque to 85 to 100 ft./lbs.
3. Assembly wing stabilizer and wing lock as shown on
the front and rear cross tubes.
IMPORTANT
Note the orientation as the rubber bumper must be
toward the outside and the 1/2-13 x 3-1/2 hex head
cap screws must be inserted from the bottom
through the wing rest mount and rubber bumper and
the flat washers and hex lock nuts located on top.
m170214 op
U-BOLT
3/4-10 HEX LOCK NUT
SCRAPER MOUNT
SCRAPER PLATE (USED WITH
OUTER TIRES ONLY)
DUAL TIRE SCRAPER
3/4-10 X 1-3/4 HEX HEAD
CAP SCREW (USED WHEN
SCRAPER PLATE NOT USED)
OR
3/4-10 X 2-1/4 HEX HEAD
CAP SCREW (USED WHEN
SCRAPER PLATE IS USED)