Landoll 7450 VT Plus - Manual (Page 51)

ASSEMBLY INSTRUCTIONS
3-33
Figure 3-34: Mounting the Bulkhead Plates and
Fittings to the Wings
Figure 3-35: Mounting the Gang Bar Hose Clamps
and Fittings
8. Install fittings into manifold according to Figures 3-25
through 3-27.
9. Install bulkhead plates to the inner and outer wings
with hose clamps (3-34 and 3-35.) Assemble
bulkhead tees and 90º swivel adapters onto each of
them.
10. Install fittings into 2-1/2” cylinders. All cylinders will
have a 90º fitting on the bottom side. The outer
cylinders on each side have a 45º fitting in the base
end and the others are a straight adapter.
11. Install hoses per Figures 3-25 through 3-27. Hose
routing to follow Figures 3-32 and 3-33.
12. Install hose clamp brackets as shown at hinge lines
with 1/2-13x1-1/2 round head square neck bolts and
nuts. Assemble hose clamp with 3/8-16 x 1-1/2 bolts
and 3/8 flange lock nuts (See Figure 3-36.)
Figure 3-36: Gang Bar Hose Clamp Placement
13. Install other hose clamps as needed to secure
hoses.
NOTE
The outer two reels will need enough slack in the hoses
to go to the end of the stops when folded so allow some
extra hose next to the cylinder.
RIGHT OUTER
WING
90 SWIVEL
ADAPTER
BULKHEAD
RUN TEE
RIGHT INNER WING
HOSE
CLAMP
BULKHEAD
PLATE
7450-reel-1
RIGHT INNER
WING
90 SWIVEL
ADAPTER
BULKHEAD
RUN TEE
CENTER FRAME
GANG BAR
HOSE CLAMPS
7450-reel-2
GANG BAR
HOSE CLAMP
PLACEMENT
7450-reel-3