Landoll 7450 VT Plus - Manual (Page 41)

ASSEMBLY INSTRUCTIONS
3-23
Figure 3-22: Rear Tow Hitch Installation
Light Installation
1. Attach lights and mounting brackets to the center
frames using u-bolts, 3/4-10 x 6 hex head cap
screws, and hex lock nuts (See Figure 3-21.) Refer
to page 2-4 thru page 2-9 for light bracket
placements.
2. Mount ag flasher control module on right hand tail
light mount using 1/4-20 x 1-1/2 hex head cap
screws and nuts. Connect rear harness to module
and connect the right/left side lights accordingly.
Route main wire harness through hose holder on
hitch, down the left side of the center frame and
across the back to the ag flasher control module
plug.
3. Connect light harness to lights.
4. Attach SMV emblem and mounting bracket to rear
center frame bar using u-bolt, 1/4-20 x 3/4 hex head
cap screws, and hex lock nuts. The SMV sign should
be mounted as shown in light bracket placements
(See Figures 2-1 thru 2-6.)
Rear Tow Hitch Installation
Refer to Figure 2-8 for rear tow hitch placement.
1. Attach rear tow hitch assembly to center frame using
hitch plates, mount plate, 3/4-10 x 8-1/2 hex head
cap screws, 3/4-10 x 9-1/2 hex head cap screws, and
3/4-10 hex lock nuts (See Figure 3-22.)
2. Move SMV from frame to rear tow hitch as shown.
3. If hydraulics are used, route through right side of
hitch tube.
4. Connect one 34” extension harness from main
warning light harness to rear tow tandem adapter
harness. Connect other 34” extension harness from
other connector on rear tow tandem adapter harness
to the ag flasher control module. Route extensions
through right side of rear tow hitch (See
Figure 3-21.)
3/4-10 X 8-1/2 HEX
HEAD CAP SCREW
HITCH PLATE
3/4-10 HEX
LOCK NUT
3/4-10 X 9-1/2 HEX
HEAD CAP SCREW
REAR TOW HITCH
MOUNT
PLATE
m167603 op
MOVE SMV HERE
ROUTE HOSES AND
WIRES THROUGH
RIGHT SIDE
HYDRAULIC KIT
MOUNTS HERE