Landoll 7450 VT Plus - Manual (Page 25)

ASSEMBLY INSTRUCTIONS
3-7
Outer Wing Frames
1. Install double hinge and locks to inner wing with
thrust washer toward rear of the machine using hinge
pin and 1-1/4-7 hex lock nut (See Figures 3-5 and
3-7). Install two fold links per hinge, placing them
over the bushing of the double hinge. Insert 1-8 x
6-1/2 hex head cap screw, wing fold spacer, and 1-8
hex lock nut to keep fold links stable while installing
outer wing.
2. Attach outer wing with thrust washer toward front of
machine (See Figures 3-5 thru 3-7.)
3. Assemble the tire and wheel assemblies (p/n
156952) to the wing frames. The wings use 12.5L x
15 (GY-FI) load range F tires with 8 bolt wheels and
2-1/4” slip-in spindles. Torque to 85 to 100 ft./lbs.
NOTE
All tire/wheel assemblies are mounted with the valve
stem facing outward.
4. Install disc gangs to inner wing frames using 3/4-10 x
2 hex head cap screws and hex lock nuts.
Figure 3-6: Thrust Washer Locations
Figure 3-7: Outer Wing Frame Hinge Assembly
DOUBLE HINGE
1-3/4 THRUST
WASHER
thrust washer locations
7450-45-fold-1
1-1/4-7 HEX LOCK NUT
2-13/16 X 1-13/16
WASHER
ON BOTH SIDES
1-3/4 X 9-3/8 PIN
W/ SNAP RINGS
1-3/4 X 9-3/4 HINGE
PIN
THRUST WASHER
(STAINLESS STEEL)
1-3/4 X 9-3/4 HINGE
PIN
1-3/4 X 9-3/8 PIN
W/ SNAP RINGS
THRUST WASHER
(STAINLESS STEEL)
RIGHT FRONT HINGE SHOWN