beautypg.com

Landoll PFT Floating Ring Pulverizer User Manual

Page 17

background image

298rev401

5K089

Page 15

WARNING LIGHTS

Mount the safety warning lights as shown.

1. Attach lamp assemblies to 5K092 brackets (amber facing forward; red and amber facing rear

ward with amber above red). See illustration for fastener requirements.

2. Connect “wishbone” wiring harness ends to connectors on lamp assemblies. (IMPORTANT:

wires are color coded on wishbone harness. Connect end with yellow wire to left side

lamp assembly. Connect end with green wire to right side lamp assembly). Run wish

bone harness wires along main frame tube to center of machine.

3. Connect “straight section” wiring harness to center connector of wishbone harness at center of

machine. Run straight section harness along drawbar tube and over to hitch point. All wires

must be firmly attached to machine frame members, or hydraulic lines, so they don’t droop or

become torn loose by field debris. Use plastic cable ties, provided, and electrical tape to secure

all wiring.

4. Check to be sure that wiring at center of machine is slack enough so as not to be stretched or

interfered with while rotating frame from transport to field working position and vice versa.

SMV SIGN

Attach the slow moving vehicle bracket as close to rear center as possible.

FIGURE 13

(

Amber only

facing front)

(Amber & Red

toward rear with

Amber above Red)

U-BOLT

5/8” THRD x 7” LONG

LOCK NUT

5/-11

5K092

BRACKET

This manual is related to the following products: