Landoll SSP2101 High Capacity Sure Stand Seeder - Manual (Page 15)

ASSEMBLY INSTRUCTIONS
2-5
Step 5
Charge the Hydraulic System. See Page 3-10.
IMPORTANT
ATTACH SEEDER TO TRACTOR: Seeder must be
raised with 3 Point Hitch or Hydraulic lift to install
roller assemblies.
Figure 2-5: Pull Seeder Step 5
Step 6
Install Stub Shafts, long shaft on left end, short shaft on
right end of front roller assembly. See Figure 2-5.
Step 7
Install Drive Sprocket onto stub shaft on left side.
Step 8
Install Flange Bearings on stub shafts. See Figure 2-6.
Figure 2-6: Pull Seeder Step 8
Set Screw,
1/2 X 3/4”
Front Roller
Assembly
4-Bolt Stub
Shaft
7-Tooth
Axle Sprocket
Lockwasher, 5/8
Nut, 5/8
Flange
Bearing