Kinze 3600 Lift and Rotate Planter (70 CM) Rev. 5/14 - Manual (Page 128)

M0249-01 Model 3600
6-24 Rev. 7/13
TM
Lubrication and Maintenance
ACTUATOR ARM ADJUSTMENT
Gap between actuator arm and stop on stop collar should be
.3 cm (± .8 mm) (⅛"(±1/32") when solenoid is NOT engaged.
Loosen nut on mounting pin and move pin in slot until there is
a .8 cm (± .2 cm) (⅛"(±1/32") gap between arm and stop on stop
collar. Retighten nut.
If the clutch or clutches fail to operate, first determine if problem is electrical or mechanical.
Place operation switch in RIGHT or LEFT position. Solenoid plunger will retract causing a clicking sound if it is
operating properly. Touch plunger with a metal object to check if it is electrically magnetized. Check clutch and wiring
harness for power with a test light or volt meter.
NOTE: R.H. clutch operates clockwise and L.H. clutch operates counterclockwise. Clutch parts such as the
wrap spring are side specific. Use correct repair part if a clutch must be repaired.
Also see “Point Row Clutch Troubleshooting” in Troubleshooting section.
.3 cm (± .8 mm)
⅛ "(±1/32") gap
NOTE: Replace all point row fuses with MDL 10 amp slow blow fuses.
Single speed point row clutch control box
(Front View)
Control box
main fuse L.H. point
row clutch R.H. point
row clutch
TESTING AND FUSE REPLACEMENT
Two- speed point row clutch control box
(Rear view)
Control box
main fuse
L.H. point row clutch
R.H. point
row clutch
R.H.
reduced rate
L.H. reduced rate