KD Scientific Legato 200 Series User Manual
Page 86

86
Appendices
K
D
S
L
e
g
a
to
2
0
0
S
e
ri
e
s
U
s
e
r’s
M
a
n
u
a
l
KD Scientific Legato 200 Series Syringe Pump User’s Manual
Publication 5617-002-Rev F
Fuse Replacement
Key Information
1.
Make sure the power cord is disconnected
from the main supply before servicing the fuse.
2. Use only Type 3AG, 1/4" x 11/4, ½ amp,
250 volt; Type T (time delay) fuses (KD
Scientific Part No. 5146-037 or equivalent).
Turn off power and remove power cord from power
module. Use a straight blade screw-driver to pry open
the access door. Remove the fuse holder and then
remove the fuses from this holder as shown in figure
below. Replace fuses, and then replace the fuse holder.
1.
Remove screw and swing cover to the side.
2. Slide battery out from under clip.
3. Install Lithium Coin Battery: 3V, 16mm CR1620
(Part No. 5155-288 or equivalent) by sliding
under clip with positive side facing out
Battery Replacement
!
CAUTION: USE ONLY SAME TYPE &
RATED BATTERY. OBSERVE POLARITY
WHEN INSTALLING.
+
phone
508.429.6809
fax
508.893.0160
web
www.kdscientific.com