KD Scientific Legato 200 Series User Manual
Page 37

37
Operating the KDS Legato 200 Series
K
D
S
L
e
g
a
to
2
0
0
S
e
ri
e
s
U
s
e
r’s
M
a
n
u
a
l
KD Scientific Legato 200 Series Syringe Pump User’s Manual
Publication 5617-002-Rev F
d. Pulse
e. Advanced Options
a. Constant Rate
b. Ramp
c. Stepped
4. When you have entered the desired name for your
Program, choose the Accept button to go to the
Program Configuration screen. Your new Program
will now be listed in the Program Select button.
5. Choose the Syringe Select button and complete
the description of the syringe by following the
procedure outlined previously in the Syringe
Selection section of this Guide.
6. To begin creating Pump Control Profile Steps,
choose the Step Definition button to enter the
Program Steps Summary screen.
7.
To add a Step to your Program, choose the Add
Step button to access the Program Steps Menu
screen. The available options include:
8. Choose the Program Step type that you want to
add to the Program. If you choose a pumping
profile (e.g. Constant Rate, Ramp, etc.) you will be
taken to the Step Definition screen for the selected
Program. If you choose Advanced Options, you
will taken to the Select Advanced Options screen.
9. Complete the parameter entry applicable to the
selected Pump Operation Profile, follow the
detailed instructions supplied in the Pump
Operation Profiles (Existing and User-Defined
Programs) section later in this Guide. If you
selected Advanced Options, follow the instructions
supplied in the Incorporating Advanced Options
Into a Program section later in this manual.
10. When you have completed all parameter entries
on the Step Definition screen or completed the
required entries for Advanced Options, choose the
button to save your changes and return
to the Program Steps Summary screen.
11. Repeat items 7-10 in this procedure to include
additional Steps in the Program.
‘BACK’
12. When you are done adding all required Steps to
the Program, choose the
button to return to
the Program Main screen.
‘BACK’
TO CREATE A NEW USER-DEFINED PROGRAM (CONTINUED)
✐
NOTE: If you do not complete the
required parameter entry for a Step,
subsequent Step additions may be ignored.
You should enter all required parameters
for a Step when creating it to ensure that
the application software can assemble your
Program without errors.
✐
NOTE: When adding a Step to a
Program, the Step is added after the
currently selected Step (i.e. the Step that is
highlighted in blue)
Program Steps Profile Menu screen
phone
508.429.6809
fax
508.893.0160
web
www.kdscientific.com