KD Scientific Legato 200 Series - Manual (Page 38)

38
Operating the KDS Legato 200 Series
K
D
S
L
e
g
a
to
2
0
0
S
e
ri
e
s
U
s
e
r’s
M
a
n
u
a
l
KD Scientific Legato 200 Series Syringe Pump User’s Manual
Publication 5617-002-Rev F
Modifying an Existing User-Defined Program
Once you have created a Program or have reviewed an
Existing Program, you may have a need to modify the
structure of the Program (i.e. the types of Steps and
Commands included, not just changes in the operating
parameters for a specific Step). The following
procedures will help you to efficiently modify a stored
Program.
CHANGING THE ORDER OF STEPS IN A PROGRAM
1. From the Program Configuration screen,
choose the Step Definition button to enter the
Program Steps Summary screen.
2. Highlight (select with a single touch) the Step for
which you want to change the order.
3. Choose the Move Step Up or Move Step Down
button, as required, to move the Step into the
position that you want it executed.
✐
NOTE: If there are Program Commands
(e.g. Go To) that link to the Step, moving
Steps can result in unexpected results as the
Command may be linked to the Step number.
You should always recheck all Program
Commands after adding, deleting or moving
Steps in a previously created Program.
DELETING A STEP FROM A PROGRAM
1. From the Program Configuration screen, choose
the Step Definition button to enter the Program
Steps Summary screen.
2. Highlight (select with a single touch) the Step that
you want to delete.
3. Choose the Delete Step button. The application
will display a warning message in the Message
Area asking you to confirm your deletion request.
4. To confirm the deletion, choose the Delete Step
button again. The Step is removed and you are
returned to the Program Steps Summary screen.
Defining Program Step Parameters
This section of the User Guide describes each of the
available functions available for use in KDS Legato 200
Series Existing and User-Defined Programs. The
information in this section is designed to help you set the
individual parameter values in each of the Program Step
options and to properly use the Advanced Options
commands.
The information that follows is organized into two sections:
• Pump Operation Profiles
• Advanced Options (Commands and I/O)
Delete Program Step showing confirmation message
on the screen
phone
508.429.6809
fax
508.893.0160
e-mail
[email protected]
web
www.kdscientific.com