JULABO SC 2500w Professional Series Recirculating Coolers - Manual (Page 42)

Menu functions
42
9.3.3. OFF-MODE – Pump motor on / off
XXXXX
OFFMODE
PMP OFF
Factory setting:
PMP
OFF
Normally the circulating pump is switched via the start/stop signal.
However, if circulation should be maintained also for the -OFF- condition,
the parameter >PMP ON< needs to be set.
Possible parameters:
PMP ON Pump motor on
PMP OFF
Pump motor off
1. Press the button until the submenu > OFFMOD < is displayed.
2.
Select the parameter with the keys .
(PMP ON / PMP OFF)
3. Press enter to store the selected parameter.
Continue: Press / or

In case of an alarm state, a shutdown of the pump motor is still
effected.
9.3.4. RESET – Factory settings
Factory setting:
NO
Use this to reset all values to factory setting (except date and time).
A RESET can only be carried out in the -OFF- condition.
Possible parameters:
NO / YES
1. Press the button until the submenu > RESET < is displayed.
2. Select the parameter with the keys (NO / YES).
3.
Press enter to store the selected parameter.

As long as the message -RUN- appears all parameters a reset to
factory settings.